Vuoi reagire a questo messaggio? Crea un account in pochi click o accedi per continuare.

e-cat

Andare in basso

250912

Messaggio 

e-cat Empty e-cat




Da qualche tempo seguo la questione dell'E-Cat
il dispositivo di Rossi e Focardi che sembra avere qualcosa a che fare con la fusione fredda o reazione nucleare debole.

Ne avevo scritto a gennaio sul mio blog...
http://robuz.wordpress.com/2012/01/05/le-cat/

in questi mesi, come avevo fatto prima, ogni tot settimane davo un'occhiata alle novità.

La cosa sembra andare avanti. Nel mondo sono aumentate le aziende interessate.

http://www.nextme.it/scienza/energia/4261-fusione-fredda-e-cat-zurigo-dettagli

Fra cui la Siemens
http://www.greenstyle.it/e-cat-termico-elettrico-confermata-la-partecipazione-di-siemens-11477.html
avatar
buzz

Messaggi : 7223
Data d'iscrizione : 25.11.11

Torna in alto Andare in basso

Condividi questo articolo su: reddit

e-cat :: Commenti

avatar

Messaggio Mar Mag 21, 2013 10:18 am  Admin

La notizia c'è anche su Forbes:

http://www.forbes.com/sites/markgibbs/2013/05/20/finally-independent-testing-of-rossis-e-cat-cold-fusion-device-maybe-the-world-will-change-after-all/

Dove riportano anche il diagramma di Ragone con inserito anche l'E-Cat:

e-cat 130520_ragone_02-809x1024

E' evidente che si tratta di una fonte di energia che va "fuori scala" rispetto alle tradizionali fonti di energia.

Qui il paper pubblicato su arXiv:

http://arxiv.org/ftp/arxiv/papers/1305/1305.3913.pdf

Due brevi estratti:

ABSTRACT

An experimental investigation of possible anomalous heat production in a special type of reactor tube named E-Cat HT is carried out. The reactor tube is charged with a small amount of hydrogen loaded nickel powder plus some additives. The reaction is primarily initiated by heat from resistor coils inside the reactor tube. Measurement of the produced heat was performed with high-resolution thermal imaging cameras, recording data every second from the hot reactor tube.

The measurements of electrical power input were performed with a large bandwidth three-phase power analyzer. Data were collected in two experimental runs lasting 96 and 116 hours, respectively. An anomalous heat production was indicated in both experiments. The 116-hour experiment also included a calibration of the experimental set-up without the active charge present in the E-Cat HT. In this case, no extra heat was generated beyond the expected heat from the electric input. Computed volumetric and gravimetric energy densities were found to be far above those of any known chemical source. Even by the most conservative assumptions as to the errors in the measurements, the result is still one order of magnitude greater than conventional energy sources.

CONCLUSIONS

The two test measurements described in this text were conducted with the same methodology on two different devices: a first prototype, termed E-Cat HT, and a second one, resulting from technological improvements on the first, termed E-Cat HT2. Both have indicated heat production from an unknown reaction primed by heat from resistor coils. The results obtained indicate that energy was produced in decidedly higher quantities than what may be gained from any conventional source. In the March test, about 62 net kWh were produced, with a consumption of about 33 kWh, a power density of about 5.3 · 105, and a density of thermal energy of about 6.1 · 107 Wh/kg. In the December test, about 160 net kWh were produced, with a consumption of 35 kWh, a power density of about 7 · 103 W/kg and a thermal energy density of about 6.8 · 105 Wh/kg. The difference in results between the two tests may be seen in the overestimation of the weight of the charge in the first test (which was comprehensive of the weight of the two metal caps sealing the cylinder), and in the manufacturer’s choice of keeping temperatures under control in the second experiment to enhance the stability of the operating cycle. In any event, the results obtained place both devices several orders of magnitude outside the bounds of the Ragone plot region for chemical sources.

Even from the standpoint of a “blind” evaluation of volumetric energy density, if we consider the whole volume of the reactor core and the most conservative figures on energy production, we still get a value of ( 7.93 ± 0.8 ) 102 MJ/Liter that is one order of magnitude higher than any conventional source.

Lastly, it must be remarked that both tests were terminated by a deliberate shutdown of the reactor, not by fuel exhaustion; thus, the energy densities that were measured should be considered as lower limits of real values.

The March test is to be considered an improvement over the one performed in December, in that various problems encountered in the first experiment were addressed and solved in the second one. In the next test experiment which is expected to start in the summer of 2013, and will last about six months, a long term performance of the E-Cat HT2 will be tested. This test will be crucial for further attempts to unveil the origin of the heat phenomenon observed so far.

Torna in alto Andare in basso

avatar

Messaggio Gio Mag 23, 2013 5:23 pm  Admin

Torna in alto Andare in basso

avatar

Messaggio Lun Lug 01, 2013 8:11 am  buzz

Nella rubrica radio web "Smart city" di Radio24 il giornalista scientifico Maurizio Melis intervista il fisico Giuseppe Levi, dell'universita' di Bologna, a proposito del recente studio sul Hot-Cat pubblicato su arxiv.org, di cui Levi e' autore con altri 6 colleghi, per lo piu' svedesi.

Questo il link con l'introduzione redatta da Melis:
http://www.radio24.ilsole24ore.com/programma/smart-city/2013-06-28/ritorno-fusione-fredda-secondo-104709.php?idpuntata=gSLAEQpDS&date=2013-06-28

E qui l'audio in formato mp3, con la breve intervista a Levi:
http://audio.radio24.ilsole24ore.com/radio24_audio/2013/130628-smart-city.mp3

Torna in alto Andare in basso

avatar

Messaggio Lun Lug 01, 2013 2:52 pm  .

la devi smettere

Torna in alto Andare in basso

Messaggio   Contenuto sponsorizzato

Torna in alto Andare in basso

Torna in alto


 
Permessi in questa sezione del forum:
Non puoi rispondere agli argomenti in questo forum.